Table of Contents
Advertisement
Connecting the Cables
Connecting the Grounding Cable
The Grounding screw (marked ╤) is located on the bottom panel of the
outdoor unit.
To connect the ground cable:
1. Connect one end of a grounding cable to the grounding screw and
tighten the grounding screw firmly.
2. Connect the other end of the grounding cable to a good ground
(earth) connection.
Connecting the Antenna Cable
To connect the RF cable (units with external antenna):
1. Connect one end of the coaxial RF cable to the RF connector
(marked
2. Connect the other end of the RF cable to the antenna.
3. The RF connectors should be sealed properly to protect against rain
and moisture
Connecting the AU-ODU's IF Cable
To connect the IF cable:
1. Connect one end of the coaxial IF cable to the IF connector on the
bottom panel of the unit
2. Verify that the length of the IF cable is sufficient to reach the
AU-IDU/Micro Base Station. See IF cable length limitation in
Cables
Manual Revision 1.0
) located on the bottom panel of the unit.
on page 2-5.
Installing the ODU
IF
2-11
Advertisement
Table of Contents
