Table of Contents
Advertisement
Reset Unit
Select this option to reset the unit. To avoid unintentional reset, you
will be prompted to confirm the reset request. Changes to some of the
configurable parameters are applied only after reset. Refer to
NPU/Micro Base Station Parameters Summary
information on which parameters are changeable in run time and which
changes are applied only after reset.
Set Factory Defaults
Select this option to set the SU parameters to their factory default
values. Refer to
on the factory default values of these parameters. The parameters will
revert to their default values after the next reset.
SW Versions Control (only for Permanent SUs)
The SU can contain two SW versions:
Main: Each time the SU resets it will reboot using the version
defined as Main.
Shadow: Normally the Shadow version is the backup version. Each
time a new SW File is downloaded to the SU, it will be stored as a
Shadow version, replacing the previous Shadow Version.
The process of upgrading to a new SW version is controlled by the NPU,
and is performed using one of the SU SW files installed in the NPU. If
the specified SU SW file does not exist in the SU, it will be downloaded
to the SU and the requested operation will be executed, as described
below. If it already exists in the SU, then actual loading is not
necessary.
The following options are available in the SW Version Control menu:
Show SW Versions
None
Download
Run from Shadow
Set as Main
Manual Revision 1.0
SU Parameters Summary
SU Menu
on page 4-83 for
on page 4-65 for information
4-53
Advertisement
Table of Contents
