Table of Contents
Advertisement
Chapter 4 - Operation and Administration
Unicast Relaying (L2 Service Type only)
The Unicast Relaying parameter determines whether the AU performs
unicast relaying. When the Unicast Relaying parameter is enabled,
unicast packets originating from devices on the wireless link can be
transmitted back to the wireless link devices. If disabled, these packets
are not sent to the wireless link even if they are intended for devices on
the wireless link.
Broadcast Relaying (L2 Service Type only)
The Broadcast Relaying parameter determines whether the AU performs
broadcast relaying. When the Broadcast Relaying parameter is enabled,
broadcast packets originating from devices on the wireless link are
transmitted by the AU back to the wireless link devices, as well as to the
backbone. If disabled, these packets are sent only to the backbone and
are not sent back to the wireless link.
Unknown Forwarding Policy (L2 Service Type only)
The Unknown Forwarding Policy parameter determines the mode of
controlling the flow of information from the backbone to the wireless
media. Select from the following options:
1 – Reject: The AU will transmit packets only to those addresses that
the AU knows to exist on the wireless link side.
2 – Forward: Enables the transmission of all packets, except those sent
to addresses that the AU recognizes as being on its wired backbone
side.
Multicast VLAN ID
The VLAN ID to be attached to mulicast messages to enable full support
of the VLAN feature.
Available values are in the range of 0 to 4094 or null (empty string) for
No Multicast VLAN ID.
Refer to
Using VLANs
configuration of Multicast VLAN ID.
Multicast QoS Profile
The QoS Profile to be used for mulicast and broadcast messages.
The QoS Profile must be one of the names that exist in the database
after being defined using the QoS Profile menu.
4-74
on page 4-65 for guidelines regarding
BreezeMAX System Manual
Advertisement
Table of Contents
