Table of Contents
Advertisement
Chapter 2 - Installation
8. Connect the DC power cable to the power jack of the PIU module. If
a redundant PIU is installed, connect a DC power cable also to the
second PIU module. Connect the power cord(s) to the -48VDC
power source(s), as follows.
A. Connect the black wire to the 48VDC contact of the power
source.
B. Connect the red wire to the + (Return) contact.
C. Connect the ground wire to the ground.
9. Connect the IF cable(s) (already connected at the other end to the
AU-ODU(s) to the ODU-1 connector(s) of the applicable AU-IDU
module(s). To avoid transmissions at undesired frequencies, verify
that the frequency and bandwidth parameters are properly
configured before connecting the IF cables.
2-28
BreezeMAX System Manual
Advertisement
Table of Contents
