Table of Contents
Advertisement
Appendix B - Using the SU Installer Monitor Program
3. Enter the name of the SW file (as called in the TFTP server) as the
SW File Name.
4. Select Perform SW Download and confirm the download request.
Wait to receive a success/failure message.
5. Following a successful download, the loaded SW version becomes
the Shadow version in the unit.
Configuration Control
Set Factory Defaults
Select this option to reset the unit and revert to the default
configuration. To avoid unintentional actions you will be prompted to
confirm the request. All parameters except the Password will revert to
the factory default values.
Ethernet Port Operation Mode
The Ethernet Port Control parameter enables viewing and defining the
operation mode of the Ethernet port
The available options are:
Show Ethernet Mode
Auto Negotiation
100 Mbps, Full-Duplex
100 Mbps, Half-Duplex
10 Mbps, Full-Duplex
10 Mbps, Half-Duplex
The default is Auto-Negotiation.
Upon selecting the Show Ethernet Mode option, the configured and
actual values will be displayed:
Current Eth Mode: the actual operation mode of the Ethernet
port.
Configured Eth Mode: the configured operation mode of the
Ethernet port.
Detected Eth Mode: the actual speed and duplex parameters of
the Ethernet port.
B-12
BreezeMAX System Manual
Advertisement
Table of Contents
