Sense Function (Sense) - ITech IT6000C Series User Manual

ООО "Техэнком" Контрольно-измерительные приборы и оборудование

3.6.3 Sense Function (Sense)

Category Parameter
Upper limit of power: P+, and
lower limit of power: P-
[On/Off] status
Config Mode
menu
Speed
V-Rise Time/I-Rise Time
V-Fall Time/I-Fall Time
Output Res
On Delay/Off Delay
•
Last: Indicates when powered on, the instrument will remain the same
parameter settings (i.e., the parameters controlled by the *SAV 0 com-
mand, see 3.4 Save and Recall
the instrument.
•
Last+Off: Indicates when powered on, the instrument will remain the
same settings as last time you turned off the instrument, but the output
state is Off.
Under the condition of Last+Off, the output switch state is not con-
strained by the *SAV 0 instruction.
4. After the parameter settings are complete, press [Enter].
For example, Last is selected, and the voltage value is set to 20V. After the
instrument is powered off and then powered on, the voltage displayed on the
interface is 20V.
This menu item is used to switch the power supply to local measurement or re-
mote sensing.
The IT6000C series power supply supports two connection methods: Local
measurement and Remote sensing. The remote sensing is used for maximizing
measurement accuracy. (Refer to
The procedures to set the menu item are as follows.
Copyright © Itech Electronic Co., Ltd.
Initial Value
Rated power value of
the instrument
Off
CV
High
0.1s
1000
0
Operations) as last time you turned off
1.4 Connecting the Device Under Test
www.tehencom.com
Basic Operation
(DUT))
32