ITech IT6000C Series User Manual page 73

ООО "Техэнком" Контрольно-измерительные приборы и оборудование
Update Select(01/01)
SN: ALL
If the U key is not detected, select Yes to detect again; if No is se-
lected, it means to exit upgrading, and the system will directly enter in-
to the main interface.
3. Select ALL, and press [Enter].
The system interface displays as follows:
Update ? (01/01)
No Yes
4. Select Yes, and press [Enter].
The system will automatically perform upgrading.
If No is selected, it means to exit upgrading, and the system will di-
rectly enter into the main interface.
5. After the upgrading is completed, you need to restart the instrument
manually.
•
System Upgrade under Parallel Mode (Only Need to Operate the Master)
1. Insert the U key into the USB interface on the front panel of the
instrument.
2. Power on the instrument. At this point, press Shift for several times till
the instrument can detect the system upgrading files in the U key.
After the system upgrading files are detected, the interface displays as
follows:
Update Select(xx/yy)
SN: ALL
xx means the number of selected instruments to be upgraded, and yy
means the number of instruments in the parallel network.
3. Select upgrade in whole or in part based on actual needs. Then, press
[Enter].
– SN: ALL
Indicates to upgrade all.
– SN1: xxxxxxxxxxxxxxxxxx
Copyright © Itech Electronic Co., Ltd.
www.tehencom.com
Basic Operation
62