Set The Communication Information (I/O Con); Set Parallel Operation Mode (Parallel) - ITech IT6000C Series User Manual

ООО "Техэнком" Контрольно-измерительные приборы и оборудование

3.6.5 Set the Communication Information (I/O Con)

3.6.6 Set Parallel Operation Mode (Parallel)

Configure the Menu Item
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
4. After the parameter settings are complete, press [Enter].
This menu item is used to set the communication information between instru-
ment and PC. The standard communication interfaces for IT6000C series power
supply are USB, LAN, CAN and VCP. You can also select the non-standard in-
terface GPIB or RS-232 based on personal requirement.
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the I/O Con and press
[Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
4. After the parameter settings are complete, press [Enter].
•
The default communication method is USB. If other communication method
is selected, the related parameters need to be set. For detailed parameter
description, refer to
•
The instrument supports the non-standard RS-232 and GPIB interfaces, and
the configuration items in the menu are dynamically displayed according to
the interface user selected.
This menu item is used to control whether the instrument is working in single
mode or in parallel mode. This chapter takes three instruments as an example
to describe how to parallelize the single units and how to return from parallel
mode to single mode.
The IT6000C series power supply supports multiple instruments to work in par-
allel mode to provide more power and current output capability.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
Copyright © Itech Electronic Co., Ltd.
5 Remote Interface Connection.
www.tehencom.com
Basic Operation
34