Sense Function (Sense); Select Trigger Source (Trig Source) - ITech IT-M3900B Series User Manual

4. After the parameter settings are complete, press [Enter].

6.7 Sense Function (Sense)

This menu item is used to switch the power system to local measurement or re-
mote sensing.
This series power system supports two connection methods: Local measure-
ment and Remote sensing. The remote sensing is used for maximizing meas-
urement accuracy. (Refer to
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
2. Turn the knob to select the Sense and press [Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
4. After the parameter settings are complete, press [Enter].

6.8 Select Trigger Source (Trig Source)

For this series power system, the List and data logging functions can be trig-
gered for running by the following methods:
Category Parameter
On Delay/Off Delay
•
Last: Indicates when powered on, the instrument will remain the same
parameter settings and output status as last time you powered off the
instrument.
•
Last+Off: Indicates when powered on, the instrument will remain the
same settings as last time you powered off the instrument, but the output
status is Off.
For example, Last is selected, and the voltage value is set to 8V. After the
instrument is powered off and then powered on, the voltage displayed on the
interface is 8V.
ter the system menu.
parameter.
•
Off: Default value, indicates turn the sense function off.
•
On: Indicates turn the sense function on.
Copyright © Itech Electronic Co., Ltd.
2.4 Connecting the Device Under Test
Basic Operation
Initial Value
0s
(DUT))
157