Set The Beeper Status (Beep) - ITech IT6000C Series User Manual

ООО "Техэнком" Контрольно-измерительные приборы и оборудование

3.6.1 Set the Beeper Status (Beep)

Main-Ver
Ctrl-Ver
FPGA-Ver
INV-Ver
2017/6/22
00:00:00
Press the composite button [Shift]+[P-set] (System) to enter the system
menu, and press [Esc] to exit the menu.
The user can turn the instrument beeper sound on or off base on personal
requirement.
The beeper sound works in the following scenarios:
•
A beeper sound produced when the front panel key is pressed.
•
When an error is generated inside the instrument, such as when the instru-
ment receives an unprocessable command in the remote state. At this time,
the instrument produces a beeper sound, and the flag "Error" appears on the
VFD.
•
When the instrument is under protection status, such as over-temperature
protection. At this time, the instrument produces the beeper sound.
The setting procedures are as follows:
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
The first displayed menu item Beep is used to set the beeper status.
2. Press [Enter] key to enter the parameter setting interface.
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
•
On: Default value, indicates the beeper is on.
•
Off: Indicates the beeper is off.
4. After the parameter settings are complete, press [Enter].
At this point, the beeper status takes effect immediately.
Copyright © Itech Electronic Co., Ltd.
Display the system version information.
Display the version information for a single
module.
Display the FPGA version information.
Display the control board version information.
Display the system time.
www.tehencom.com
Basic Operation
30