Connecting Dnl910 And Dnl920 Loggers To The Network - Fourier DataNet User Manual

For loggers remaining connected to AC power, to prevent the
logger from heating up again following the initial charge cycle,
the logger will receive a one minute trickle charge each day
rather than stay continually charged. This is sufficient to
ensure the logger doesn't self-discharge and will maintain the
logger's full charge status.
Refer to section 3.9.3 for more details on the DataNet loggers'
power supply.
2.5.2.
* Includes the PA models
1. Turn on the logger by pressing the Scroll button
The unit will beep when turned on. As soon as the unit is
turned on, the LCD screen will display the following
message:
Fourier Systems
Logger
2. The logger will then start scanning for networks. The LCD
will indicate how many networks were found in range, and
will announce when the scan is complete. Locked
networks will not be listed.
Scan for network Scan for network
To join the network created by your Receiver (there may be
other networks created by your colleagues) scroll through the
Connecting DNL910 and
DNL920 Loggers to the
Network
Scan for network Scan for network
Found 2 networks Found 2 networks
20
.
Scan complete Scan complete