Alarm Setup Tab - Fourier DataNet User Manual

Close
Clicking Close will close the Setup dialog without saving any
of your configurations.
Note: Running the logger clears the logger memory. All
previously recorded data will be erased when you begin a new
logging session.

4.12.2. Alarm Setup Tab

A major feature of the DataNet system is the ability to
configure alarm levels into the loggers so any breach of these
levels as recorded on the data logger is monitored by the
software, and the user is notified via Email/SMS/audible and
visual indicators.
The Alarm Setup tab lets you configure each sensor for the
following alarms:
•
Low
•
Pre-Low
•
Pre-High
•
High
•
Contact Open / Contact Close (when the Contact sensor
is selected)
Using the Pre Alarms gives the user ample warning of a
possible breach of real alarm levels, so necessary measures
can be taken to prevent such a breach.
Simply select the check box for the type of alarm you wish to
be notified. You can select all alarms too. Enter the alarm
value in the text box.
143