Table of Contents
Advertisement
5.4 Creates the Lens File
■ Creating lens files
This section describes the setting method for serial interface supported lenses.
1
Display the ENGINEER MENU screen to select "LENS" and press the ENTER button.
2
Select "FILE SETTING" on the SUB MENU screen and press the ENTER button.
3
Select "No.1" for "NUMBER".
Select from No.1 - No.16.
Specify the number you want to set for NUMBER.
Note that assigning the same lens number overwrites
the data.
4
Select "ON" for "AUTO SEL".
"EXTENDER" are automatically acquired.
Note:
compatibility.
- In the case of serial interface supported lens, the
model name automatically acquired from the lens is
5
Select "AUTO" for "FILE SET", and then select
"START".
The data acquisition starts.
114
UHK-430/CCU-430 1710 VER2 (E)
Advertisement
Table of Contents
