Configuration - Ikegami CCU-430 Operation Manual

■ CONFIGURATION

Set the external connection etc..
[ETHERNET SETUP] [PGM NO.] [POWER CONTROL] etc.
Setting Item
ETHERNET SETUP
― IP ADDRESS
192.168. 1.100
― SUBNET MASK
― DEFAULT GATE WAY
xxx.xxx.xxx.xxx
― SPEED/DUPLEX
SET
PGM NO.
― CAM PGM NO. SET
OFF
FRONT ID DISPLAY OFF
POWER CONTROL
― OCP CAM PWR CTRL ---
― CAM CODE ---
SAFETY&H.PWR ---
FIBER SINGLE MODE OFF
ENGINEER SET FILE RENEW
― PASSWORD
****
― 0123456789
― FILE SELECT
― DATA RENEW MODE
PUSH SET --> RENEW
PASSWORD ENTRY
― INPUT ****
― RENEW ****
― CONFIRM
****
123456789
FIRMWARE UPDATE
― MAIN SOFT 6149Vxx.xx.xx
― ALL UPDATE
6182Vxx.xx.xx
― SUB SOFT 6139Vxx.xx.xx
― HD VP FPGA2 6091Vxx.xx.xx
― HD VP FPGA3
6093Vxx.xx.xx
― TRX VP FPGA1 6089Vxx.xx.xx
― TRX VP FPGA2 6090Vxx.xx.xx
― TRX VP FPGA3 6093Vxx.xx.xx
― RET PRC FPGA1 6102Vxx.xx.xx
― RET PRC FPGA2 6103Vxx.xx.xx
― PLS/AUX FPGA
― MPU FPGA
6117Vxx.xx.xx
12G OUT FAGA 6128Vxx.xx.xx
USB DATA SAVE
― LOG DATA
PUSH SET --> SAVE
OTHERS
― PM TALLY SEL
― REM OPT ALARM LEVEL
REAR FAN SPEED
Initial setting Setting value
FULL
EXECUTE
OFF, 1 to 99
OFF / ON
OFF / ON
Reconfirm
UHK-430/CCU-430 1710 VER2 (E)
6.2 CCU Menu Configuration and Contents
Description, Remarks
Set the ETHERNET
Sets the program number.
Sets the ID display number for the entire CCU front side.
Sets the ON/OFF of the display for the entire CCU front side.
Selects the operation mode based on the status of the OCP
camera power switch.
Sets the fiber single mode.
Inputs the password for updating.
The initial value is 0000.
Updates the firmware.
Displays "---" when the optional module is not implemented.
Displays "---" when the optional module is not implemented.
Displays "---" when the optional module is not implemented.
Collects the log data.
Sets the optical receiver level of the optical alarm on the
remote panel.
Sets the rotating speed of the fan motor on the back side of
CCU.
6
143