Table of Contents
Advertisement
Chapter 2 - Installation
2.1.1 ETHERNET CONNECTION
1.
Check if the Ethernet card and the TCP/IP are installed on the PC before beginning
installation. (If the TCP/IP protocol is not installed, go to Appendix B for the
installation procedures).
2.
Connect the Ethernet cable (yellow) from the SMC7003ADSL's Ethernet port to the
Ethernet port of the PC.
3.
Connect the DSL cable (green) in to the DSL wall jack and the other end in to
receptacle marked "DSL RJ-11" on the back of the device.
4.
Connect the AC Power Adapter to the AC wall output and connect the round cable
end to the "Power" receptacle on the back of the device.
5.
Connect the AC Power Adapter to the AC wall output and connect the round cable
end to the "Power" receptacle on the back of the SMC7003ADSL.
6.
Turn ON the unit by using the ON/OFF switch in the back of the device to the ON
position. You must have a steady (green) Power LED. The Sync LED will be a
blinking (green) LED initially and will become steady (green) once the connection is
established.
8
SMC7003ADSL (version 1.0)
Advertisement
Table of Contents
