Table of Contents
Advertisement
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or removing a
battery.
2
Use a plastic scribe to pry out the system battery.
Figure 109. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
Figure 110. Installing the system battery
Next steps
1
If removed,
Install the low profile or full height X1 expansion card
2
If applicable, connect the cables to the expansion card(s).
3
Follow the procedure listed in
4
While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
5
Enter the correct time and date in the System Setup Time and Date fields.
6
Exit the System Setup.
Optional internal USB memory key
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If installed,
remove the low profile expansion card
Steps
1
Locate the USB port or USB memory key on the system board.
152
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
riser.
risers.
system.
Advertisement
Table of Contents
