Next steps
1
Follow the procedure listed in
2
Install any device drivers required for the card as described in the documentation for the card.
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air
shroud.
4
If installed,
remove the rear drive
5
Remove the BOSS card.
NOTE:
The procedure to remove the BOSS card is similar to the
Steps
1
Loosen the screw and lift the retention strap that secures the M.2 SSD module on the BOSS card.
2
Lift the M.2 SSD module and slide it out of the connector on the BOSS card.
Figure 89. Removing the M.2 SSD module
Next step
Replace the M.2 SSD
module.
After working inside your
system.
Safety
instructions.
Before working inside your
cage.
system.
removing an expansion
Installing and removing system components
card.
133