Table of Contents
Advertisement
Figure 44. Installing intrusion switch
2
Slide the intrusion switch until it is firmly seated in the intrusion switch slot.
3
Connect the intrusion switch cable to the connector on the system board.
Next steps
1
Installing the internal PERC riser
2
Follow the procedure listed in
Drives
Removing a drive blank
The procedure for removing 2.5-inch and 3.5-inch drive blanks is identical.
Prerequisites
1
Follow the safety guidelines listed in
2
If installed,
Removing the front bezel
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Press the release button, and slide the drive blank out of the drive slot.
After working inside your
system.
Safety
instructions.
Installing and removing system components
91
Advertisement
Table of Contents
