Figure 108. Installing the rear drive cage
Next steps
1
Reconnect all the disconnected cables to the rear drive backplane.
2
Install all the drives.
3
Follow the procedure listed in
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If applicable, disconnect the power or data cables from expansion card(s).
4
If installed,
remove the low profile or full height X1 expansion card
Steps
1
Locate the battery socket. For more information, see the
After working inside your
system.
Safety
instructions.
Before working inside your
system.
risers.
System board jumpers and
Installing and removing system components
connectors.
151