Table of Contents
Advertisement
CAUTION:
To prevent damage to the memory module or the memory module socket during installation, do not bend or flex
the memory module. You must insert both ends of the memory module simultaneously.
2
Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.
3
Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the memory module
in the socket.
CAUTION:
Do not apply pressure at the center of the memory module; apply pressure at both ends of the memory module
evenly.
NOTE:
The memory module socket has an alignment key that enables you to install the memory module in the socket in only
one orientation.
4
Press the memory module with your thumbs until the socket levers firmly click into place.
Figure 57. Installing a memory module
Next steps
1
Installing the air shroud
2
Follow the procedure listed in
3
To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS >
Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the installed
memory.
4
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly
seated in the memory module socket.
5
Run the system memory test in system diagnostics.
Processors and heat sinks
Removing a processor and heat sink module
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system is powered down. Allow the heat sink to cool
before removing it.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
106
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
