Table of Contents
Advertisement
Card type
Card,Controller (EMULEX/QLOGIC)
Card,Network (Mellanox/QLOGIC/INTEL/
Solarflare)
BOSS M.2 (SATA) (Dell)
PCIe SSD PCIe Card (Samsung)
Card,Controller (QLOGIC)
Card,Network (Broadcom/INTEL/Mellanox/
QLOGIC)
Card,Controller (EMULEX/QLOGIC)
Intel OPA NIC (Intel OPA)
Card,Network (Solarflare)
BOSS M.2 (SATA) (Dell)
Card,Network (Broadcom/INTEL)
PERC9.14G/PERC10 (FXN)
RAID - PERC9.14G/PERC10 (Internal)
Removing expansion card from the expansion card riser
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If applicable,
Removing the air
4
If applicable, disconnect the cables from the expansion card.
5
When removing a card from low profile, full height X1, or butterfly riser, ensure that the PCIe card holder latch is closed.
Steps
1
Pull and lift up the expansion card retention latch lock to open.
2
Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
116
Installing and removing system components
Slot priority
2
2
2
3, 4, 2, 5
3, 4, 2, 5
4, 3, 5
4, 3, 5
4, 3, 5
4, 3, 5
4, 3, 5
6, 5, 4, 3
Integrated Slot
Integrated Slot
Safety
instructions.
Before working inside your
shroud.
system.
Maximum number of cards
1
1
1
4
4
3
3
3
3
3
4
1
1
Advertisement
Table of Contents
