Table of Contents
Advertisement
Figure 124. Installing right control panel
Next steps
1
Installing PERC card into the internal PERC riser
2
Follow the procedure listed in
System board
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create a
recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this system
board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on
your drives.
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in module is installed,
it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM plug-in module breaks the
cryptographic binding, and it cannot be re-installed or installed on another system board.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the following:
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
a
Air shroud
b
All expansion cards and risers
170
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
