Table of Contents
Advertisement
4
Enter the correct time and date in the System Setup's Time and Date fields.
5
Exit the System Setup.
6
To test the newly installed battery, remove the system from the enclosure, for at least an hour.
7
Reinstall the system into the enclosure, after an hour.
8
Enter the System Setup and if the time and date are still incorrect, see the
Optional internal USB memory key
Replacing optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Steps
1
Locate the USB port or USB memory key on the system board.
2
If installed, remove the USB memory key from the USB port.
3
Insert the replacement USB memory key into the USB port.
Next steps
1
Follow the procedure listed in
2
While booting, press F2 to enter
IDSDM
Removing the optional internal dual SD module
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air
shroud.
NOTE:
The procedure to remove IDSDM and the BOSS M.2 card is the same.
Steps
1
Using the Phillips #2 screwdriver, loosen the retention screw that connects the internal dual SD module (IDSDM) to the system board.
2
Lift the release tab that secures the IDSDM to the system board.
3
Holding both ends of the IDSDM, lift the IDSDM out of the IDSDM/BOSS M.2 connector on the system board.
90
Installing and removing system components
Safety
instructions.
Before working inside your
After working inside your
system.
System Setup
and verify that the system detects the USB memory key.
Safety
instructions.
Before working inside your
Getting help
system.
system.
section.
Advertisement
Table of Contents
