Installing The M.2 Ssd Module - Dell EMC PowerEdge R540 Installation And Service Manual

Installing the M.2 SSD module

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the BOSS card
NOTE: The procedure to remove the BOSS card is similar to the
Steps
1 Connect the M.2 SSD module to the connector on the BOSS card.
2 Place the retention strap on the M.2 SSD module, and tighten the screw to secure the module.
Figure 90. Installing the M.2 SSD module
Next steps
1 Install the BOSS card.
NOTE: The procedure to install the BOSS card is similar to the
2 Install the applicable air
3 Follow the procedure listed in
134 Installing and removing system components
Safety instructions.
Before working inside your
shroud.
After working inside your
system.
removing an expansion
Installing expansion card on the system
system.
card.
board.