Table of Contents
Advertisement
•
Torx #T8 screwdriver
•
Wrist grounding strap
You need the following tools to assemble the cables for a DC power supply unit:
•
AMP 90871-1 hand-crimping tool or equivalent
•
Tyco Electronics 58433-3 or equivalent
•
Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE:
Use alpha wire part number 3080 or equivalent (65/30 stranding).
Optional front bezel
NOTE:
The procedure to remove the front bezel with and without the LCD panel is the same.
Removing the front bezel
Prerequisite
Follow the safety guidelines listed in
Steps
1
Unlock the bezel by using the bezel key.
2
Press the release button, and pull the left end of the bezel.
3
Unhook the right end, and remove the bezel.
Figure 23. Removing the front bezel with the LCD panel
Safety
instructions.
Installing and removing system components
69
Advertisement
Table of Contents
