f. Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key: 15.9 mm width x 57.15 mm length x 7.9 mm height.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
2. If installed, remove the USB memory key from the USB port.
Figure 112. Removing the internal USB memory key
a. USB memory key
b. USB port
3. Insert the replacement USB memory key into the USB port.
Safety instructions
Before working inside your system
System board jumpers and connectors
Getting help
System board jumpers and connectors
on page 43.
on page 44.
section.
Installing and removing system components
section.
section.
123