Table of Contents
Advertisement
Optional IDSDM or vFlash module
Removing the MicroSD card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Steps
1
Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the System board jumpers and connectors section.
2
Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Next steps
1
Follow the procedure listed in
2
Installing the MicroSD card
Installing the MicroSD card
Prerequisites
Follow the safety guidelines listed in
NOTE:
To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the
cards during removal.
Steps
1
Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot. To locate IDSDM/vFlash, see the System board jumpers and connectors section.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2
Press the card into the card slot to lock it into place.
Next step
Follow the procedure listed in
Removing the optional IDSDM or vFlash card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Steps
1
Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the System board jumpers and connectors section.
2
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Safety
instructions.
Before working inside your
After working inside your
Safety
instructions.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
system.
system.
Installing and removing system components
135
Advertisement
Table of Contents
