Figure 100. Installing the backplane
Next steps
1
Connect all the cables to the backplane.
2
Install all the
drives..
3
Install the backplane
cover..
4
Install the air shroud
5
Follow the procedure listed in
Removing the 3.5-inch rear drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before removing the
backplane.
CAUTION:
You must note the number of each hard drive and temporarily label them before removal so that you can replace them
in the same locations.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove all the drives from the rear drive cage.
4
Disconnect all the cables from the backplane.
5
Remove the rear drive cage.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
143