Table of Contents
Advertisement
Figure 92. Installing optional IDSDM/vFlash card
Next steps
1
Install the MicroSD cards.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2
Follow the procedure listed in
LOM riser card
Removing the LOM riser card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If installed,
remove the
4
If installed,
remove the rear drive
Steps
1
Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2
Release the two blue side plastic snaps holding the LOM riser card.
3
Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
4
Slide the LOM riser card towards the front of the system until the Ethernet connectors or the Small form-factor pluggable (SFP) are
clear of the slot in the back of the system.
After working inside your
Safety
instructions.
Before working inside your
risers.
cage.
system.
system.
Installing and removing system components
137
Advertisement
Table of Contents
