Figure 55. Installing the internal cooling fan
Next steps
1
Install the air shroud.
2
Follow the procedure listed in
Optional internal USB memory key
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. To boot from
the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in
System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE:
To locate the internal USB port on the system board, see the
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key: 15.9 mm width x 57.15 mm length x 7.9 mm height.
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the air shroud.
Steps
1
Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
2
If installed, remove the USB memory key from the USB port.
3
Insert the replacement USB memory key into the USB port.
82
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
System board jumpers and connectors
System board jumpers and connectors
system.
section.
section.