Table of Contents
Advertisement
Figure 114. Installing the VGA module
Next steps
Route the VGA cable and connect it to the VGA connector on the system board. For locating the connector, see the
jumpers and connecters
Install the air
shroud.
Install the backplane
cover.
Install the front
bezel.
Follow the procedure listed in
.
Optional internal USB memory key
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE:
To locate the internal USB port on the system board, see the System board jumpers and connectors section.
For configurations that support USB 3.0 module, the USB 3.0 module cable connects to the internal USB port on the system board. In this
scenario, the default internal USB port is available under the backplane cover. The position of the default internal USB port may vary
depending on the configuration of your system.
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
Follow the safety guidelines listed in
Follow the procedure listed in
Steps
Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
If installed, remove the USB memory key from the USB port.
section.
After working inside your
Safety
instructions.
Before working inside your
Jumpers and connectors
system.
system.
.
Installing and removing system components
System board
151
Advertisement
Table of Contents
