Figure 55. Installing the internal cooling fan
Next steps
1.
Install the air shroud.
2. Follow the procedure listed in
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key: 15.9 mm width x 57.15 mm length x 7.9 mm height.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air shroud.
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
Next steps
1. Follow the procedure that is listed in
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
58
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
System board jumpers and connectors
After working inside your
system.
System board jumpers and connectors
system.
section.
system.
section.