Table of Contents
Advertisement
Figure 80. Installing the system battery
Next steps
1. Install the LOM riser card.
2. If applicable, connect the cables to the expansion card(s).
3. Follow the procedure listed in the
4. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the
Replace the optional internal USB memory key
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
•
Remove the air
shroud.
About this task
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
Steps
1. Locate the USB port or USB memory key on the system board.
After you work inside your
system.
Safety
instructions.
Before you work inside your
Getting help
section.
Jumpers and connectors
system.
Installing and removing system components
section.
107
Advertisement
Table of Contents
