Table of Contents
Advertisement
Figure 120. Installing power interposer board
Next steps
1
Installing a processor and heat sink module
2
Installing the air shroud
3
Follow the procedure listed in
Control panel
Removing the left control panel
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Removing the air shroud
4
Removing the PERC card from the internal PERC riser
Steps
1
Disconnect the control panel cable from the system board connector.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
2
Using a Phillips #1 screwdriver, remove the screws that secure the left control panel assembly to the system.
166
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
