Figure 42. Installing PERC card into internal PERC riser
Next steps
1
Installing the internal PERC riser
2
Installing the air shroud
3
Follow the procedure listed in
Intrusion switch
Removing the intrusion switch
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Removing the air shroud
4
Removing the internal PERC riser
Steps
1
Disconnect the intrusion switch cable connected to the system board.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board.
2
Slide the intrusion switch out of the intrusion switch slot.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
89