Table of Contents
Advertisement
WARNING:
Reversing polarity when connecting DC power wires can permanently damage the power supply or the system.
2
Insert the copper ends into the mating connectors and tighten the captive screws at the top of the mating connector using a Phillips
#2 screwdriver.
WARNING:
To protect the power supply from electrostatic discharge, the captive screws must be covered with the rubber
cap before inserting the mating connector into the power supply.
3
Rotate the rubber cap clockwise to fix it over the captive screws.
4
Insert the mating connector into the power supply.
Power interposer board
Removing power interposer board
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Removing the air shroud
4
Disconnect all the cables connected from the PIB to the system board.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board.
5
Removing a processor and heat sink module
Steps
1
Using a Phillips #2 screwdriver, remove the screw securing the power interposer board (PIB) to the system.
2
Press the blue release latch on the PIB to release it from the hook on the PSU cage.
3
Lift the board and slide it out at an angle to disengage the guide pins on the board.
164
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
