Figure 76. Installing expansion card into butterfly riser
Next steps
1
If applicable, connect the cables to the expansion card.
2
If applicable,
install air
3
Follow the procedure listed in
4
Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the system board
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Disconnect any cables connected to the expansion card.
Steps
1
Pull and lift up the expansion card retention latch lock to open.
2
Hold the expansion card by the edge and pull the card to disconnect from the system board connector.
shroud.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
123