Removing Expansion Card From The Expansion Card Riser - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 89. Installing the expansion card riser (Riser 4)
Next steps
1. If required, re-connect the cables to the expansion card.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.

Removing expansion card from the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the cables from the expansion card.
4. Remove the expansion card
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. Pull the black card holder before removing the card from the riser.
3. Hold the expansion card by the edges. and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
116 Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 27.
on page 26.
on page 27.