Table of Contents
Advertisement
Figure 83. Installing the expansion card riser (Riser 4)
Next steps
1. If required, re-connect the cables to the expansion card.
2. Follow the procedure listed in
After working inside your system
on page 26.
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
Safety instructions
on page 25.
2. Follow the procedure listed in the
Before working inside your system
on page 26.
3. If applicable, disconnect the cables from the expansion card.
Steps
1. Pull and lift the expansion card retention latch lock to open.
NOTE:
Pull the black card holder before removing the card from the riser.
Installing and removing system components
89
Advertisement
Table of Contents
