Figure 56. Installing the low profile right riser
Next steps
1. If required, re-connect the cables to the expansion card.
2.
Install the air
shroud.
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If applicable, disconnect the cables from the expansion card.
Steps
1. Pull and lift up the expansion card retention latch lock to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
NOTE:
The numbers on the image does not depict the exact steps. The numbers are just for representation of
sequence.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
75