Uniden BCD996XT User Manual page 596

Set End Code
This setting determines how the scanner treats the transmission end code.
Yes The scanner pays attention to the analog transmission end code.
Ignore The scanner ignores the transmission end code and waits for carrier drop.
Press [E / yes / gps] to accept the selection and return to the previous menu.
Emergency Alert
The following options can be set in this menu.
Set Alert Tone
Set Alert Light
Press [E / yes / gps] to enter the setting.
Set Alert Tone
If "Set Alert Tone" is selected, user can determines how the scanner treats the Talk Group that set with
emergency flag.
Off The scanner ignores the emergency flag.
Alert1-9 The scanner sounds the Emergency Alert Tone when any Talk Group goes active with the
emergency flag set.
When you select "Off", the scanner returns to the previous menu.
When you select "Alert1-9", the scanner goes to the Alert Level selection.
Auto The alert is set to the same volume as normal audio.
Level1-15 The alert is fixed to the selected audio level.
Press [E / yes / gps] to accept the entry and return to the previous menu.
Set Alert Light
If "Set Alert Light" is selected, you can select from the following Alert Light Pattern selections.
Off The alert light will not turn on
On The alert light is set to on
Slow Blink The alert light blinks slowly
Fast Blink The alert light blinks fast
Press [E / yes / gps] to accept the entry and return to the previous menu.
Set ID Format (DEC/HEX)
You can select the format for TGIDs on MOT type system.
Decimal Format
Hex Format
Press [E / yes / gps] to accept the entry and return to the previous menu.
Thursday, May 14, 2009
The scanner uses decimal format for TGIDs.
The scanner uses hexadecimal format for TGIDs.
38