Uniden BCD996XT User Manual page 542

BandScopeMode < UnidenMan4 < TWiki
This page applies only to the
see:
Band Scope mode
Band Scope mode is a special type of Search mode where the scanner displays the strength
of any signal it finds.
In a band scope search, the scanner starts at the lowest frequency in the range and
moves up the search range.
In Max Hold Search mode, the scanner displays the strongest signal that it found.
If you manually set the mode to NFM or FM, the scanner will not reliably detect
signals that are modulated in either FMB or WFM.
To turn on Band Scope mode:
Band Scope mode is the default setting for Search Key 3. To turn on Band Scope mode,
enter Search mode, then tap FUNCTION + 3 (SR3) . (To change the Search Key
assignment, see
Reading the display in Band Scope mode
file:///C|/Documents%20and%20Settings/POpitz/My%20D...ments/temp/CDImage_090515/Manual/BandScopeMode.html (1 of 4)5/26/2009 11:13:58 AM
BCT15X Band Scope Mode
BCD996XT Band Scope Mode
Search Keys#Programming Search
BCD396XT and BC346XT. For other models
Keys.)