Uniden BCD996XT User Manual page 802

<COMMAND CLC>
Get/Set Close Call Settings
Controller → Radio
CLC[\r]
CLC,[CC_MODE],[CC_OVERRIDE],[RSV],[ALTB],[ALTL],[ALTP],[CC_BAND],[LOUT],
[HLD],[QUICK_KEY],[NUMBER_TAG],[RSV],[ALT_PATTERN][\r]
Radio → Controller
CLC,[CC_MODE],[CC_OVERRIDE],[RSV],[ALTB],[ALTL],[ALTP],[CC_BAND],[LOUT],
[HLD],[QUICK_KEY],[NUMBER_TAG],[RSV],[ALT_PATTERN][\r]
CLC,OK[\r]
[CC_MODE]
[CC_OVERRIDE]
[ALTB]
[ALTL]
[ALTP]
[CC_BAND]
[LOUT]
[HLD]
[QUICK_KEY]
[NUMBER_TAG]
[ALT_PATTERN]
[RSV]
Get/Set Close Call Settings.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
: Mode
: Override
: Alert Beep
: Alert Tone Level
: Close Call Pause
3 : 3 sec
10 : 10 sec
30 : 30 sec
60 : 60 sec
: Close Call Band
(each # is 0 or 1)
0 means OFF
1 means ON
: Lockout for CC Hits with Scan(0:Unlocked/1:Lockout)
: System Hold Time for CC Hits with Scan (0-255)
: Quick Key for CC Hits with Scan
*".(dot)" means that nothing is assigned.
: Number tag
: Alert Light Pattern(0:ON / 1:SLow / 2:Fast)
: Reserve Parameter
244
( 0:OFF / 1:CC PRI / 2:CC DND)
(1:ON / 0:OFF)
(0:OFF / 1-9:Tone No)
(0:AUTO/ 1-15)
5 : 5 sec
15 : 15 sec
45 : 45 sec
INF : Infinite
(7digit ####### )
||||||+- 800MHz+
|||||+-- UHF
||||+--- Reserve
|||+---- VHF HIGH
||+----- AIR BAND
|+------ VHF LOW2
+------- VHF LOW1
(0-999 / NONE)
* This is always only ",".
(0 – 99/.(dot) )