Uniden BCD996XT User Manual page 1044

BC346XTSrchCloCallOpt < UnidenMan4 < TWiki
If you turn this feature on, whenever the scanner detects a signal on a common repeater
input frequency, it automatically searches for that signal on the output frequency. If it
finds the signal on the output frequency, the scanner displays Repeater Found and
switches to monitor the output frequency.
Max Auto Store
Enter the maximum number of hits you want the scanner to store during Search and
Store mode or Close Call Auto Store mode. When the number of stored hits reaches the
number you enter here, the scanner stops storing hits. Enter a number from 1 to 256 .
Set Delay Time
Set the number of seconds the scanner should wait after a transmission stops before
moving on to the next channel. Select 0, 1, 2 (default), 5, 10, or 30 seconds.
To have scanner leave the channel after a designated number of seconds whether the
transmission stops or not, select one of the negative values. Choose -10 seconds to have
the scanner leave the channel after 10 seconds even if the transmission is still going on;
choose -5 seconds or -2 seconds to have the scanner leave after 5 seconds or 2 seconds,
respectively.
Set Attenuator
Turn on attenuation to reduce the signal strength by 20 dB. You can turn on attentuation
for individual frequencies and channels or for entire sites. If you turn on attenuation for a
site, all frequencies within that site will be attenuated.
This page applies to the following scanner(s):
Guide
file:///C|/Documents%20and%20Settings/POpitz/My%20...p/CDImage_090515/Manual/BC346XTSrchCloCallOpt.html (3 of 3)5/26/2009 11:16:48 AM
BC346XT Users