Uniden BCD996XT User Manual page 503

<COMMAND LOF >
Lock Out Frequency
Controller → Radio
LOF,[FRQ][\r]
Radio → Controller
LOF,OK[\r]
[FRQ]
This command locks out a frequency.
The frequency is added to L/O list.
This command is only acceptable in Programming Mode.
<COMMAND CLC>
Get/Set Close Call Settings
Controller → Radio
CLC[\r]
CLC,[CC_MODE],[CC_OVERRIDE],[RSV],[ALTB],[ALTL],[ALTP],[CC_BAND],[LOUT],
[HLD],[QUICK_KEY],[NUMBER_TAG],[ ALT_COLOR],[ALT_PATTERN][\r]
Radio → Controller
CLC,[CC_MODE],[CC_OVERRIDE],[RSV],[ALTB],[ALTL],[ALTP],[CC_BAND],[LOUT],
[HLD],[QUICK_KEY],[NUMBER_TAG],[ ALT_COLOR],[ALT_PATTERN][\r]
CLC,OK[\r]
[CC_MODE]
[CC_OVERRIDE]
[ALTB]
[ALTL]
[ALTP]
[CC_BAND]
[LOUT]
[HLD]
[QUICK_KEY]
[NUMBER_TAG]
[ALT_COLOR]
[ALT_PATTERN]
[RSV]
Get/Set Close Call Settings.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
: Frequency
: Mode
: Override
: Alert Beep
: Alert Tone Level
: Close Call Pause
3 : 3 sec
10 : 10 sec
30 : 30 sec
60 : 60 sec
: Close Call Band
(each # is 0 or 1)
0 means OFF
1 means ON
: Lockout for CC Hits with Scan(0:Unlocked/1:Lockout)
: System Hold Time for CC Hits with Scan (0-255)
: Quick Key for CC Hits with Scan
: Number tag
: Alert Light color
(OFF,BLUE,RED,MAGENTA,GREEN,CYAN,YELLOW,WHITE)
: Alert Light Pattern(0:ON / 1:SLow / 2:Fast)
: Reserve Parameter
(250000-13000000)
( 0:OFF / 1:CC PRI / 2:CC DND)
(1:ON / 0:OFF)
(0:OFF / 1-9:Tone No)
(0:AUTO/ 1-15)
5
15
45
INF
(7digit ####### )
*".(dot)" means that nothing is assigned.
(0-999 / NONE)
* This is always only ",".
254
: 5 sec
: 15 sec
: 45 sec
: Infinite
||||||+- 800MHz+
|||||+-- UHF
||||+--- VHF HIGH2
|||+---- VHF HIGH1
||+----- AIR BAND
|+------ VHF LOW2
+------- VHF LOW1
(0 – 99/.(dot) )