Uniden BCD996XT User Manual page 957

SrchCloCallOpt < UnidenMan4 < TWiki
( CTCSS/DCS Search), P25 NAC codes ( P25 NAC Search), or neither ( Off). (The
scanner ignores this setting in AM, WFM, and FMB bands.)
CTCSS / DCS Search (BC346XT and BCT15X)
Choose whether the scanner searches an active frequency for CTCSS/DCS tones ( On)or
not ( Off). (The scanner ignores this setting in AM, WFM, and FMB bands.)
Repeater Find
If you turn this feature on, whenever the scanner detects a signal on a common repeater
input frequency, it automatically searches for that signal on the output frequency. If it
finds the signal on the output frequency, the scanner displays Repeater Found and
switches to monitor the output frequency.
Max Auto Store
Enter the maximum number of hits you want the scanner to store during Search and
Store mode or Close Call Auto Store mode. When the number of stored hits reaches the
number you enter here, the scanner stops storing hits. Enter a number from 1 to 256 .
Set Delay Time
This setting is used to set the delay time for Quick Search, Close Call, and the CC Hits
system.
Set the number of seconds the scanner should wait after a transmission stops before
moving on to the next channel. Select 0, 1, 2 (default), 5, 10, or 30 seconds.
To have scanner leave the channel after a designated number of seconds whether the
transmission stops or not, select one of the negative values. Choose -10 seconds to have
the scanner leave the channel after 10 seconds even if the transmission is still going on;
choose -5 seconds or -2 seconds to have the scanner leave after 5 seconds or 2 seconds,
respectively.
Set Attenuator
Turn on attenuation to reduce the signal strength by 20 dB. When you turn on this
file:///C|/Documents%20and%20Settings/POpitz/My%20D...ents/temp/CDImage_090515/Manual/SrchCloCallOpt.html (3 of 4)5/26/2009 11:16:02 AM