Uniden BCD996XT User Manual page 788

[OFFSETn]
Get/Sets Band Plan Setting for MOT 800 custom/VHF/UHF site.
In set command, if only "," parameters are send the Band Plan setting of the
site will not changed.
The set command is aborted if any format error is detected.
When the system protect bit is ON, all the parameters will be send as a reserve
parameter in the Radio -> Controller command.
Before using this command, user should set Band Plan type as "Custom" first by
using SIF command.
This command is only acceptable in Programming Mode.
<COMMAND TFQ>
Get/Set Trunk Frequency Info
Controller → Radio
TFQ,[CHN_INDEX][\r]
TFQ,[CHN_INDEX],[FRQ],[LCN],[LOUT],[RSV],[NUMBER_TAG],[VOL_OFFSET], [RSV] [\r]
Radio → Controller
TFQ,[FRQ],[LCN],[LOUT],[REV_INDEX],[FWD_INDEX],[SYS_INDEX],[GRP_INDEX],[RSV],[NU
MBER_TAG],[VOL_OFFSET],[RSV][\r]
TFQ,OK[\r]
[CHN_INDEX]
[FRQ]
[LCN]
[LOUT]
[REV_INDEX]
[FWD_INDEX]
[SYS_INDEX]
[GRP_INDEX]
[NUMBER_TAG]
[VOL_OFFSET]
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
For Motorola or EDACS SCAT System, [LCN] is ignored.
When the system protect bit is ON, except [REV_INDEX], [FWD_INDEX], [SYS_INDEX],
[GRP_INDEX], other parameters will be send as a reserve parameter in the Radio -
> Controller command.
[NUMBER_TAG] and [VOL_OFFSET] are just used for SCAT system.
"6875": 68.75k
"8000": 80.0k
"8750": 87.5k
"9500": 95.0k
: Offset n (-1023 to 1023)
: Trunk Frequency Index
: Trunk Frequency
: LCN
(EDACS WIDE/NARROW system: 0 to 20
: Lockout
: Reverse Frequency Index of the Site
: Forward Frequency Index of the Site
: System Index of the Frequency
: Index of the Site
: Number tag
: Volume Offset
"7000": 70.0k
"8125": 81.25k
"9000": 90.0k
"10000": 100.0k
LTR system: 0 to 30)
(0:Unlocked / 1:Lockout)
(0-999 / NONE)
(-3 - +3)
230
"7500": 75.0k
"8500": 85.0k
"9375": 93.75k