Uniden BCD996XT User Manual page 979

AnalogWXOperation < UnidenMan4 < TWiki
Set the number of seconds the scanner should wait after a transmission stops before
moving on to the next channel. Select 0, 1, 2 (default), 5, 10, or 30 seconds.
To have scanner leave the channel after a designated number of seconds whether the
transmission stops or not, select one of the negative values. Choose -10 seconds to have
the scanner leave the channel after 10 seconds even if the transmission is still going on;
choose -5 seconds or -2 seconds to have the scanner leave after 5 seconds or 2 seconds,
respectively.
Set Attenuator
Turn on attenuation to reduce the signal strength by 20 dB. You can turn on attentuation
for individual frequencies and channels or for entire sites. If you turn on attenuation for a
site, all frequencies within that site will be attenuated.
Set Record (BCT15 Only)
Turn on this option if you want the weather mode audio to be included on the rear
RECORD OUT jack.
WX Alt Priority
Select On if you want the scanner to check the weather channels in the background
during Scan, Search, or Close Call mode. The scanner can't run Weather Alert Priority
check in Search and Store, Close Call Auto Store, Band Scope, or Tone-Out modes.
This page applies to the following scanner(s):
Guide
file:///C|/Documents%20and%20Settings/POpitz/My%20D...s/temp/CDImage_090515/Manual/AnalogWXOperation.html (3 of 3)5/26/2009 11:16:08 AM
BCT15X BC346XT Users