Using Preloaded Systems - Uniden BCD996XT User Manual

UsingPreloadedSystems < UnidenMan4 < TWiki

Using Preloaded Systems

Your scanner is factory preloaded with some of the most listened-to systems in the US.
If you are fortunate enough to live in an area where one of these systems can be
received, then you might have something to listen to right out of the box. Note that the
preloaded systems are not intended as final programming: You'll need to set the scanner
up to suit what you really want to listen to. This is just intended to show that the scanner
really works and gives you something to monitor while you get your own programming
taken care of.
Notes:
This page applies to the BCD396XT, BCD996XT, and BC346XT. The BCT15X
uses preprogrammed state-by-state data, instead.
System information changes all the time. The preloaded systems were accurately
programmed several months prior to first production. It is possible that a system
preloaded in the scanner is no longer operational with the preloaded settings.
Turning On/Off Preloaded Systems
To turn a preloaded system on or off, press SCAN, then press ./no then the two-digit
System Quick Key.
Preloaded Systems
Refer to the tables below to see the systems preloaded into your scanner.
BC346XT
SQK
21
22
23
24
25
26
file:///C|/Documents%20and%20Settings/POpitz/My%20D...mp/CDImage_090515/Manual/UsingPreloadedSystems.html (1 of 3)5/26/2009 11:12:18 AM
Name
Atlanta GA
Boston MA
Charlotte NC
Chicago IL
Columbus OH
Dallas TX