Figure 65: Removing The Nut And Washer From The Grounding Post - Allied Telesis AT-SBx908 Installation Manual

Figure 65. Removing the Nut and Washer from the Grounding Post
5. Attach the grounding lug and wire to the grounding post. Refer to
Figure 66 on page 116.
Review the following before installing the grounding wire:
 You should angle the wire to the right so that you can open the
plastic window to access the positive and negative terminals on the
terminal block.
 You may route the cable either above or below the locking handle.
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
Grounding
post
115